32 32 050 Removing and installing/replacing lock cylinder for steering lock (up to 09/2005)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 32 3 110 . See STEERING & WHEEL ALIGNMENT - SPECIAL TOOLS .
Necessary preliminary tasks:
- Disconnect battery negative lead
- Remove steering column trims .
- Remove ring antenna . See 61 31 020 REMOVING AND INSTALLING/REPLACING IGNITION STARTER SWITCH .
Insert ignition key into lock cylinder in such a way that release opening (arrow) remains accessible.
Turn ignition key to "R" position.
Insert special tool 32 3 110 into release opening (arrow) until end cap (1) is released.
Slide end cap (1) to ignition key and remove with special tool 32 3 110.
Pull out lock cylinder with end cap (1) and ignition key, turn ignition key forward and back if necessary.
Installation:
Insert lock cylinder with end cap (1) and ignition key into steering column.
Align end cap (1) by way of opening to steering column and press into place.
Turn ignition key to "zero" position and remove.