31 35 007 Removing and installing/replacing holder for left or right push rod/stabilizer
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Remove front wheel .
Remove stabilizer link from holder (1). See 31 35 005 Removing and installing/replacing push rod (stabilizer link) for left/right stabilizer .
Release screw (2).
Tightening torque 31 35 10AZ . See FRONT AXLE - TIGHTENING TORQUES -- 650I
Support swivel bearing with workshop jack and a suitable mounting.
Unscrew nut (1).
Remove holder (2) for brake hose, pulse generator and if necessary brake pad sensor.
Remove screw (4) with holder (3) towards front.
Installation:
Replace self-locking nut.
Tightening torque 31 31 3AZ . See FRONT AXLE - TIGHTENING TORQUES -- 650I