31 12 080 Removing and installing/replacing both tension struts
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove front wheel
- Remove front assembly underside protection
- Remove steering gear cover at side
- If necessary, remove wheel suspension cover
Release nuts (1) and pull out screw (3).
Installation:
Replace self-locking nut.
Tighten bolt connection in normal position .
Tightening torque 31 12 1AZ . See FRONT AXLE - TIGHTENING TORQUES -- 650I
Release nut (2); if necessary, grip at Torx socket.
Turn swivel bearing a little and remove tension strut.
Installation:
Keep tension strut to swivel bearing connection clean and free from oil and grease.
Replace self-locking nut.
Tightening torque 31 12 19AZ . See FRONT AXLE - TIGHTENING TORQUES -- 650I