31 10 010 Removing and installing/replacing reinforcement plate

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe safety instructions for raising the vehicle
Driving without reinforcement plate is not permitted!

Necessary preliminary tasks:

Remove underbody protective plate

Release screws (1) and remove reinforcement plate.

Installation:

Replace screws and insertion nuts.

Tightening torque 31 10 9AZ. See FRONT AXLE - TIGHTENING TORQUES -- 650I

Fig 1: Identifying Reinforcement Plate Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If applicable, remove heat shield.