84 11 610 Removing and installing/replacing eject box (cordless keypad handset)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 341

Unlock telephone mounting (1) and fold upwards.

Release catch (2) of cover (3) from telephone mounting (1).

Release centre console base (4) in direction of arrow.

Feed out centre console base (4) with cover (3) and remove.

Installation:

Make sure centre console base (4) and cover (3) are correctly seated.

Fig 1: Releasing Catch Of Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure guide pins (1) of cover (3) are correctly seated in guide of centre console base (4).

Guide pins (1) and catches (2) of cover (3) must not be damaged or missing.

Fig 2: Identifying Guide Pins, Catches And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Turn plug connection (3) in direction of arrow and feed out.

Unfasten plug connection (3) and disconnect.

If necessary, unlock antenna plug and disconnect.

Release screws (1).

Remove telephone mounting (2).

Installation:

Make sure cable guide is correctly laid.

Fig 3: Unfastening Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock eject box (1) with special tool 00 9 341 and towards top rear out of telephone mounting (2).

Installation:

Make sure eject box (1) is correctly seated.

Fig 4: Unlocking Eject Box

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on telephone mounting (2) must not be damaged or missing.

Fig 5: Identifying Catches And Telephone Mounting

Courtesy of BMW OF NORTH AMERICA, INC.