LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> X5 48i >> Repair and Diagnosis >> External Pages >> Different car >> Section 1057 (Engine - Repair (N62)) >> 61 Intake Manifold >> 11 61 050 Removing And Installing Intake Air Manifold (N62)

11 61 050 Removing And Installing Intake Air Manifold (N62)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 750i, 2008 BMW 750Li, and 2008 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.

Remove ACOUSTIC COVER .

Remove design cover.

Remove center of bulkhead.

Remove intake hose.

Remove INJECTION PIPE .

On rear side of manifold, unlock and disconnect plug on differential pressure sensor and on servomotor.

Unlock and detach vent hose (1).

Remove cable from holder.

Fig 1: Identifying Vent Hose
G04740332Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws.

Remove intake air manifold (2) upwards with aid of a second person.

Fig 2: Identifying Intake Air Manifold
G04740333Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Clean sealing faces (1) on intake air manifold (2).

Fig 3: Identifying Sealing Faces On Intake Air Manifold
G04740334Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Clean sealing face (1) on left and right.

Replace gasket on left and right.

Fig 4: Identifying Sealing Face On Left And Right
G04740335Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Check air intake system for leaks.

scientia non olet · About LEMON Manuals