11 37 040 Removing And Installing/Replacing Right Eccentric Shaft Sensor (N62/N62TU)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 750i, 2008 BMW 750Li, and 2008 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.

(cylinder bank 1 to 4)

Necessary preliminary tasks:

Remove RIGHT CYLINDER HEAD COVER

Unfasten screws.

Remove eccentric shaft sensor (1).

Fig 1: Identifying Eccentric Shaft Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Read out fault memory of control unit of Digital Motor Electronics (DME).

Check stored fault messages.

Rectify faults.

Now clear the fault memory.