11 24 571 Replacing All Conrod Bearings (N62/N62TU)

Special tools required: 

• 00 2 590
• 00 9 120
• 11 2 110

(piston removed) 

The letter (1) denotes the crankshaft construction stage.

The numbers (2) denote the bearing shell classification for the relevant bearing position from 1 to 5 (main bearing cap).

Fig 1: Identifying Crankshaft Construction Stage And Bearing Shell Classification

Courtesy of BMW OF NORTH AMERICA, INC.

Install new conrod bearing shells.

Insert one red and one blue bearing shell for each conrod.

Install piston.

Fig 2: Inserting Bearing Shell In Conrod

Courtesy of BMW OF NORTH AMERICA, INC.

Check connecting-rod bearing clearance: 

Piston in BDC position.

Fit special tool 00 2 590 (Plastigage Type PG 1) to the oilfree crankshaft.

Fit bearing caps so that pair numbers match up.

Fig 3: Locating Bearing Caps

Courtesy of BMW OF NORTH AMERICA, INC.

Use conrod bolts to check conrod bearing clearance.

Tighten down conrod bolts with special tool 00 9 120 or special tool 11 2 110.

Tightening torque: 11 24 1AZ  . See CONNECTING RODS AND BEARINGS for specs.

Fig 4: Identifying Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Remove bearing cap and read off bearing play at width of flattened plastic thread with assistance of measurement scale.

CONROD BEARING CLEARANCE .

• Remove plastic thread.
• Lubricate crankshaft and bearing shells.
• Install new conrod bolts.
  Fig 5: Checking Conrod Bearing Clearance

  Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down conrod bolts with special tool 00 9 120 or special tool 11 2 110.

Tightening torque: 11 24 1AZ  . See CONNECTING RODS AND BEARINGS for specs.

Fig 6: Identifying Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.