11 23 010 Removing And Installing/Replacing Vibration Damper (N62/N62TU)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 750i, 2008 BMW 750Li, and 2008 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove ALTERNATOR DRIVE BELT
Remove A/C compressor drive belt. See REPLACING A/C COMPRESSOR DRIVE BELT (N62) or REPLACING A/C COMPRESSOR DRIVE BELT WITH BELT TENSIONER (N62/N62TU) .
Remove REMOVING AND INSTALLING/REPLACING FAN COWL WITH ELECTRIC FAN (N62, N62TU)

Release screws and remove vibration damper (1).

NOTE:

When working with BMW ALPINA B7 vehicles, the additional belt pulley of the radial seal must also be removed.

When replacing screws, pay attention to a changed screw length for BMW ALPINA B7 vehicles.

Fig 1: Identifying Vibration Damper

G04739753

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Vibration damper is secured on hub with an alignment pin (4).

Fig 2: Identifying Vibration Damper Alignment Pin

G04739754

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Set bore hole (2) in the vibration damper (1) onto the dowel pin the in hub.

Fit disk (3).

Replace screws.

Tightening torque: 11 23 3AZ . See VIBRATION DAMPER for specs.

Fig 3: Identifying Disk And Vibration Damper

G04739755

Courtesy of BMW OF NORTH AMERICA, INC.