11 13 020 Removing And Installing/Replacing Oil Sump Bottom Section (N62/N62TU)
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 750i, 2008 BMW 750Li, and 2008 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove REINFORCEMENT PLATE
- Remove oil drain plug and drain engine oil.
Unlock plug connection (1) on oil level sensor and disconnect.
Release screws and remove oil sump bottom section (2).
Tightening torque: 11 13 2AZ . See OIL PAN for specs.
Installation:
Clean sealing surfaces.
Replace seal.
Replace screws.
When replacing oil sump bottom section:
Convert oil level sensor.
Replace sealing ring.