11 12 729 Checking Cylinder Head For Water Leaks (N62/N62TU)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 750i, 2008 BMW 750Li, and 2008 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

11 9 430
11 9 431
11 9 432
11 9 433

(cylinder head dismantled)

Prepare special tool kit 11 9 430.

NOTE:

Special tool kit 11 9 430 can be used for cylinder bank 1 to 4 and cylinder bank 5 to 8.

Place special tool 11 9 431 on cylinder head sealing surface, insert screws (special tool 11 9 433) and tighten down.

Seal coolant aperture with special tool 11 9 432 and tighten down.

Fig 1: Identifying Special Tools On Cylinder Head Sealing Surface

Courtesy of BMW OF NORTH AMERICA, INC.

Connect compressed air hose (1) to pressure gauge.

Immerse cylinder head in a water bath. Inspection pressure 4.5 bar.

Check cylinder head for escaping air (cracks).

NOTE:

If necessary, add cleaning agent to water bath.

Fig 2: Identifying Air Hose

Courtesy of BMW OF NORTH AMERICA, INC.