11 25 Pistons with Rings and Pins N62TU
PISTONS WITH RINGS AND PINS N62TU SPECIFICATION
| 1st groove | ||
| Height | mm | 1.2 -0.010-0.030 |
| End clearance | mm | 0.1-0.3 |
| Axial play | mm | 0.020-0.070 |
| 2nd groove | ||
| Height | mm | 1.5 -0.010-0.030 |
| End clearance | mm | 0.20-0.40 |
| Axial play | mm | 0.020-0.060 |
| 3rd groove | ||
| Height | mm | cannot be measured |
| End clearance | mm | 0.2-0.9 |
| Axial play | mm | cannot be measured |
PISTONS WITH RINGS AND PINS N62TU B48 SPECIFICATION
| Piston and pin are paired to each other - replace together only. | ||
| Measuring point "A" (position) | mm | 18 |
| Piston diameter at measuring point "A" | ||
| Original, stage 0 (new dimension) | mm | 93.986 +/- 0.016 |
| Oversize, stage 1 (new dimension) | mm | 93.236 +/- 0.016 |
| Oversize, stage 2 (new dimension) | mm | 933.486 +/- 0.016 |
| Piston installation clearance (piston new) | mm | 0.001-0.044 |
| Piston installation clearance (piston worn) | mm | 0.026-0.073 |
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.10 |