37 12 012 Carrying Out Ride-Height-Calibration
NOTE:
Ride-height-calibration must be carried out after the following work:
- Removal/replacement of ride-height sensor or its control rod
- Replacement of wiring harness
- Replacement of air supply unit control unit
- Replacement of Vertical Dynamics Management control unit
Connect BMW diagnosis system.
Switch on ignition.
Carry out ride-height-calibration (menu item: "Service function").
Version with Run Flat Indicator: initialize Run Flat Indicator. See 36 11 500 INITIALIZING RUN FLAT INDICATOR (RPA)
Version with Tyre Pressure Control: carry out resetting. See 36 11 503 RDC RESETTING