Necessary preliminary tasks

WARNING: This page is about a different variant/trim than selected.

Disconnect plug connection (1) on inlet solenoid valve (2).

Release screw (3).

NOTE: Secure support and sealing ring against falling down.

Remove inlet solenoid valve (2) with bracket towards front.

Disconnect plug connection (6) on exhaust solenoid valve (5).

Release screw (4).

Fig 1: Identifying Solenoid Valve With Plug Connection And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Secure support and sealing ring against falling down.

Remove exhaust solenoid valve (5) with bracket towards front.

Tightening torque 11 36 3AZ .

IMPORTANT: Risk of mixing up plug connections (1 and 6).

Installation: