11 12 719 Resurfacing cylinder head sealing face (N52K)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove cylinder head, see 11 12 100 Removing and installing cylinder head (N52K) .
- Remove exhaust camshaft, see 11 31 028 Removing and installing/replacing exhaust camshaft (N52K) .
- Remove intermediate lever on inlet side, see 11 37 010 Removing and installing/replacing intermediate levers (N52K) .
Check evenness of cylinder head sealing faces with a standard straight-edge (1).
NOTE:
Max. deviation from level (longitudinal) 0.10 mm
Check evenness of cylinder head sealing faces with a standard straight-edge (1).
NOTE:
Max. deviation from level (transversal) 0.05 mm
Check cylinder head for water leaks, see 11 12 729 Checking cylinder head for water leaks (N52K) .
Assemble engine.