27 10 720 Replacing Servomotor (ATC 700)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: After replacement, the "Repair" service function must be carried out with in the BMW diagnosis system.

Disconnect plugs (1 and 2).

Tightening torque 27 00 14AZ, seeTRANSFER BOX IN GENERAL .

Fig 1: Identifying Plugs And Servomotor

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws and remove servomotor from transfer box.

Tightening torque 27 00 13AZ, seeTRANSFER BOX IN GENERAL .

Fig 2: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.