27 10 710 Replacing classification resistor for control motor S63 (ATC 700)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Delete previous resistance values when replacing the resistor. Using BMW diagnosis system, work through test program in accordance with instructions.
Necessary preliminary tasks:
- Remove exhaust system. See EXHAUST - REPAIR - X5 (6 CYL) or EXHAUST - REPAIR - X5 (V8) .
- Remove heat shield
Disconnect connector (1). Release screw (2) and remove resistor. Tightening torque 27 00 14AZ, seeTRANSFER BOX IN GENERAL .