17 11 046 Removing and Installing/Replacing Module Carrier (N52K)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove fan cowl with electric fan. See 17 11 035 Removing and Installing/Replacing Fan Cowl With Electric Fan (N52K)
- Draining coolant. See 17 00 005 Draining and Adding Coolant In Radiator (N52K)
- Remove coolant radiator. See 17 11 000 Removing and Installing Radiator (N52K)
- Draw off fluid from power steering
Installation:
Bleed power steering unit. See 32 13 006 BLEEDING POWER STEERING UNIT
- Unlock hydraulic lines on cooling loop and disconnect
- Secure A/C condenser against damage and against falling down.
Press lock (1) and remove holder (2) downwards.
Illustration shows the left holder: The same procedure applies to the opposite side.
Installation:
Rubber mounts fall out easily, ensure correct installation position.
Remove module carrier (1) towards bottom.
When replacing module carrier:
Convert power steering cooling loop. See 17 11 370 Removing and Installing/Replacing Power Steering Cooling Coil (N62TU/N52K/M57T2) .
Add final details to vehicle.
Check system for leaks.