13 62 560 Removing and Installing/Replacing Air-Mass Flow Sensor (N52 / N52K / N53)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Read out fault memory of DME control unit; if necessary, work through test schedules
Switch off ignition

Release bolts.

Unlock plug (1) and remove.

Pull air-mass flow sensor (2) out of upper section of intake filter housing.

NOTE: Check stored fault messages.

Now clear the fault memory.

Fig 1: Identifying Plug And Air-Mass Flow Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Now clear the fault memory.