12 14 524 Replacing Pulse Generator On Exhaust Camshaft (N52K)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Lever out expansion rivets (1).

Press lock (2) and raise intake duct (3).

Detach intake duct (3) from air filter housing and remove.

Fig 1: Locating Ignition Coil Covers Screws And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fig 2: Identifying Plug Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Replace screw.

Remove pulse generator (2).

Fig 3: Locating Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Now clear the fault memory.