12 14 523 Replacing Inlet Camshaft Pulse Generator (N52, N52K, N51, N53)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection). See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
Necessary preliminary tasks:
- Read out fault memory of DME control unit.
- Switch off ignition
- Remove If necessary, remove radiator cover
Unlock plug (1) and remove.
Release bolt..
Installation:
Replace screw.
Tightening torque 12 14 3AZ 12 14 ELECTRONIC SHIFT UNITS OR CONTROL UNITS .
Remove pulse generator (2).
NOTE:
Check stored fault messages.
Now clear the fault memory.
Now clear the fault memory.