11 72 000 Removing And Installing/Replacing Air Pump (N62)

WARNING: This page is about a different variant/trim than selected.

Remove upper section of intake filter housing.

Release retaining screws on coolant expansion tank.

Remove suction filter housing.

Remove raw air housing.

Unlock and disconnect pressure and suction lines (1).

Loosen screws (2).

Loosen screw (3).

Fig 1: Identifying Pressure And Suction Lines Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Remove front splash guard.

Remove trim panel at bottom right.

Unlock plug (1) and remove.

Unscrew bolt (3).

Remove air pump (2).

Fig 2: Identifying Air Pump Bolt And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts.

Unclip plug (1).

Remove holder from air pump.

Fig 3: Locating Holder From Air Pump And Plug

Courtesy of BMW OF NORTH AMERICA, INC.