11 37 024 Removing And Installing/Replacing Servomotor For Right Eccentric Shaft (N62/N62TU)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Follow instructions issued by diagnosis tester.
Risk of damage to intermediate shaft.

(cylinder bank 1 to 4)

Necessary preliminary tasks:

IMPORTANT: Follow instructions issued by diagnosis tester.

Unlock plug (1) on servomotor (2) and disconnect.

Fig 1: Identifying Plug On Servomotor

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws.

Rotate servomotor (2) until no longer engaged in spline teeth of eccentric shaft.

Fig 2: Rotating Servomotor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace sealing ring on spacer.

Install servomotor (1) and screw in up to spacer.

Rotate servomotor (1) into correct installation position.

Install and tighten down screws.

Fig 3: Identifying Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Read out fault memory of control unit of Digital Motor Electronics (DME).

Check stored fault messages.

Rectify faults.

Now clear the fault memory.