12 13 511 Replacing Ignition Coil (N62TU)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release screws and remove holder (1).

Pull ignition coil covers (2) out of rubber grommets.

Fig 1: Pulling Ignition Coil Covers Out Of Rubber Grommets

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug fastener (1) of ignition coil.

Fig 2: Identifying Plug Fastener Of Ignition Coil

Courtesy of BMW OF NORTH AMERICA, INC.

Detach ignition coil connector in direction of arrow.

Pull out ignition coil (2).

This procedure is applicable to all ignition coils.

Fig 3: Pulling Ignition Coil

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert rubber seal on ignition coils (2) between guides.

Fig 4: Inserting Rubber Seal On Ignition Coils Between Guides

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

NOTE: Read out DME fault memory.
Check function of DME.