11 12 719 Milling Cylinder Head Sealing Face (N62/N62TU)

WARNING: This page is about a different variant/trim than selected.

(cylinder head dismantled)

Check evenness of cylinder head sealing face with a standard straight-edge (1).

NOTE: Maximum plane deviation: longitudinal 0.10 mm.

Fig 1: Identifying Cylinder Head Sealing Face With Standard Straight-Edge

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Maximum plane deviation: transversal 0.05 mm.

Machining limit . See ENGINE - TECHNICAL DATA - V8 (N62TU) .

Fig 2: Identifying Cylinder Head Maximum Plane Deviation
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: A cylinder head seal 0.3 mm thicker than usual can be obtained for machined (milled) cylinder heads.

Fig 3: Identifying Cylinder Head Seal

Courtesy of BMW OF NORTH AMERICA, INC.