65 50 057 Removing and installing/replacing Central Information Display (CID)

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with NOTES on protection against electrostatic damage (ESD protection).

Necessary preliminary tasks

Remove CENTRE FRESH-AIR GRILLE .

Release screws (1) and feed out CID (2) towards bottom.

Tightening torque 65 50 1AZ .

Fig 1: Identifying CID And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections (1) and unclip cable from holders (2).

Remove CID (3).

Installation:

Holders (2) must not be damaged!

Make sure cable is correctly routed through holders (2).

Fig 2: Identifying CID, Holders And Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.