51 13 116 Removing and installing/replacing cowl panel cover

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove both WINDSCREEN WIPER ARMS .
Remove both microfilter housing covers . See 64 31 101 REMOVING AND INSTALLING/REPLACING LEFT MICROFILTER HOUSING COVER or 64 31 106 REMOVING AND INSTALLING/REPLACING RIGHT MICROFILTER HOUSING COVER .

Release clips (1).

Feed out cover (2) towards top.

Installation:

If necessary, replace faulty clips (1) and associated grommets in body.

Fig 1: Identifying Cowl Panel Cover And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure grommets (1) are correctly seated on wiper pivots.

Grommets (1) for wiper pivots must not be damaged.

Fig 2: Identifying Wiper Pivot Grommets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Cowl panel cover (1) must be correctly guided on right and left under windscreen cover (2).

Fig 3: Identifying Cowl Panel Cover And Windscreen Cover

Courtesy of BMW OF NORTH AMERICA, INC.