61 67 100 Removing and installing/replacing high-pressure nozzle of headlight cleaning system on left (or right)

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary tasks

Remove FRONT BUMPER TRIM .

Use special tool 00 9 340 to lift the cover (1).

Fig 1: Lifting Cover Using Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Slowly pull out high-pressure nozzle of headlight washer system (1) at cover (2).

Unclip cover (2) in direction of arrow and remove.

Allow high-pressure nozzle of headlight washer system (1) to slide back slowly.

Fig 2: Uncliping Cover

Courtesy of BMW OF NORTH AMERICA, INC.

To prevent excessive escape of washer fluid, seal off end of high pressure line with special tool 13 3 010 .

Catch any escaping washer fluid if necessary.

Fig 3: Escaping Washer Fluid And Seal Off End Of High Pressure Line With Special Tool (13 3 010)

Courtesy of BMW OF NORTH AMERICA, INC.

Raise retaining bracket (1) and detach high-pressure line (2) in direction of arrow from high-pressure nozzle of headlight washer system (4).

Raise retaining lugs (3) in direction of arrow and feed high-pressure nozzle of headlight washer system (4) towards rear out of front side panel.

Installation note:

Keep plug connection for high-pressure nozzle (4) and high-pressure line (2) clean and free from grease.

Fig 4: Detaching High-Pressure Line

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure high-pressure line (2) is correctly engaged on high-pressure nozzle (4) and high-pressure nozzle (4) correctly seated on front side panel respectively.

Carry out a function test before fitting bumper trim.

If necessary, top up washer fluid.