65 50 121 Removing and installing rear cabin monitor (complete)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) , see 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Remove fresh-air grille in rear cabin , see 64 22 191 REMOVING AND INSTALLING/REPLACING REAR CABIN FRESH-AIR GRILLE .
Remove trim for rear cabin monitor base at front and rear , see 65 50 150 Removing and installing/replacing trim for rear cabin monitor base at front and rear .

Release screws (1) and remove rear cabin monitor with holder (2).

Disconnect associated plug connections and feed out leads.

Tightening torque 65 52 1AZ , see 65 52 CD/DVD DRIVES AND SPECIAL DEVICES .

Fig 1: Identifying Rear Cabin Monitor Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Ensure correct cable routing (1) on both sides.

Fig 2: Identifying Correct Cable Routing

Courtesy of BMW OF NORTH AMERICA, INC.