63 11 845 Replacing left LED fan (middle)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove left headlight with LED technology .

NOTE: Graphic similar!

Turn protective cap (1) counterclockwise and remove.

IMPORTANT: Risk of damage due to moisture penetration!

Installation note: Check seal. Replace protective cap (1) if necessary. Comply with Instructions for replacing the protective cap . Protective cap (1) must lock correctly! Turn the protective cap (1) clockwise to end stop (A)!

Fig 1: Turning Protective Cap Clockwise To End Stop

Courtesy of BMW OF NORTH AMERICA, INC.

WARNING: Danger of injury from cutting tool; wear gloves that provide protection against cutting.

Open repair cap as shown using suitable tool (e. g. cutter knife). Installation note: Repair opening is closed again using the plug contained in the repair kit.

Fig 2: Opening Repair Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1). Release screws (2) using tool 2 296 785. Tightening torque 1.5 Nm. Take fan (3) out of headlight.

Fig 3: Removing Fan From Headlight

Courtesy of BMW OF NORTH AMERICA, INC.