62 30 010 Removing and installing/replacing headup display

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection see 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) ).

IMPORTANT: Comply with notes and instructions on handling optical waveguides , see 61 00 ... NOTES ON HANDLING OPTICAL FIBERS .
Risk of damage!
Do not scratch lens of head-up display.

Necessary preliminary tasks:

Remove instrument panel trim , see 51 45 031 REPLACING INSTRUMENT PANEL TRIM .
E71:

Remove windscreen air duct , see 64 22 ... REMOVING AND INSTALLING WINDSCREEN AIR DUCT .

Remove sound insulation (1) from head-up display.

Disconnect plug connection (2).

Release screws (3). Tightening torque 62 30 2AZ , see 62 30 HEAD-UP DISPLAY .

Carefully feed out head-up display towards top.

Installation:

Clean lens of head-up display.

Adjust head-up display , see 62 30 517 Adjusting head-up display .

Fig 1: Identifying Sound Insulation, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming/coding .