52 26 311 Removing and installing/replacing lock for left or right rear seat backrest

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Unclip lock trim on backrest edge in direction of arrow (1).

Slide back of lock trim in outward direction and remove in direction of arrow (2).

Fig 1: Sliding Back Of Lock Trim

G04792101

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining lugs on trim must not be damaged.

Fig 2: Locating Retaining Lugs

G04792102

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!

Insert plastic wedge from outside between trim (1) and lock.

Carefully lever outer side of trim (1) with plastic wedge upwards out of catch.

Lever inner side of trim (1) with plastic wedge out of catch.

Remove trim upwards.

Fig 3: Levering Inner Side Of Trim

G04792103

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out backrest cover (1) in working area.

Fig 4: Levering Out Backrest Cover

G04792104

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws and feed lock (1) out of rear seat backrest.

Tightening torque: 52 26 05AZ , see 52 26 REAR SEATS (THROUGH-LOADING SYSTEM) .

Fig 5: Identifying Rear Seat Backrest Lock

G04792105

Courtesy of BMW OF NORTH AMERICA, INC.