52 17 205 Removing and installing/replacing both rear panels on left or right front seat backrest

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Operation is shown on the left seat. When removing from the right seat, transpose the pull and striking sides accordingly.

Rear panel upper section:

Grip between rear panel and backrest cover on tunnel side until clip can be felt (do not pull).
At same time, firmly punch towards middle of seat on inner side (tunnel side) at top.
Upper retainers spring out of seat guide.
Pull upper rear panel up out of lower guides.

Fig 1: Pulling Panel Up Out Of Lower Guides

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

Retainer
Guide
Upper rear panel

Fig 2: Identifying Upper Rear Panel, Guide And Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

Rear panel trim lower section:

Grip between rear panel and backrest cover on tunnel side until clip can be felt (do not pull).
At same time, firmly punch towards middle of seat on inner side (tunnel side) at top.
Upper retainers spring out of seat guide.
Pull lower rear panel up out of lower guides

Fig 3: Pulling Lower Rear Panel Up Out Of Lower Guides

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip springs (1) on left and right.

Remove lower rear panel (3) upwards out of guide (2).

Fig 4: Identifying Lower Rear Panel, Guide And Springs

Courtesy of BMW OF NORTH AMERICA, INC.