52 17 027 Removing and installing/replacing pressure distributor for active passenger seat

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove seat cover with padding for passenger seat , see 52 17 400 Removing and installing/replacing seat cover for left or right front seat (comfort) .

Unscrew left and right nuts (1).

Remove carrier plate towards front from seat mechanism.

Fig 1: Removing Carrier Plate

G06213169

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Pressure distributor and pneumatic pockets form a single unit and can only be replaced as a single component.

Unlock plug connection (1) on drive and disconnect.

Unlock plug connection (2) on control unit and disconnect.

Fig 2: Identifying Plug Connection

G06213170

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip pressure distributor (1) in marked area.

Installation:

Replace faulty clips.

Fig 3: Identifying Pressure Distributor Clips

G06213171

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip pneumatic pockets (1) with supports on left and right from flex mat.

Feed pneumatic pockets (1) through flex mat towards bottom.

Fig 4: Unclipping Pneumatic Pockets

G06213172

Courtesy of BMW OF NORTH AMERICA, INC.

Open quick connector (1).

Feed out hose through fleece mat and backrest frame.

Fig 5: Identifying Quick Connector

G06213173

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

Carry out operational check.