52 16 393 Removing and installing/replacing front left or right crash-active head restraint

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Read and comply with safety regulations for handling airbag modules and pyrotechnical belt pretensioners, see 72 00... SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
Incorrect handling may result in triggering of the crash-active head restraint and thereby cause injury.

Switch off ignition!

Necessary preliminary tasks:

Disconnect battery negative lead , see 61 20 900 DISCONNECTING AND CONNECTING BATTERY NEGATIVE LEAD .
Remove rear panel , see 52 14 198 Removing and installing or replacing rear panel on left or right front seat backrest .

Unfasten plug connection (1) and disconnect.

Feed out wiring harness from head restraint height adjustment and foam material.

Fig 1: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out locking clamps (1)

Fig 2: Identifying Locking Clamps

Courtesy of BMW OF NORTH AMERICA, INC.

Lift out head restraint.

Fig 3: Lifting Out Head Restraint

Courtesy of BMW OF NORTH AMERICA, INC.