4. Bonding
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
- 4.1 Components without pre-fitted adhesive tape
- Pull off liner* from adhesive tape
- Position adhesive tape on component and stick on
- Press down adhesive tape over entire bonding area
- Continue with Point 4.2
* Liner is the protective film on the adhesive tape
- 4.2 Components with pre-fitted adhesive tape
- Pull off liner* from adhesive side (if bonding area is large, do not pull off liner completely)
- Align component in correct position on vehicle
- Press down component over entire bonding area
* Liner is the protective film on the adhesive tape