Preparation for installation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Prepare plastic nozzle(s) for shaping adhesive bead (when not using the standard nozzle C), can be cut to size during the air drying time.
Lay a sample bead of approx. 50 mm; if OK, apply immediately to window glass.
- Interruption must be < 5 seconds (incorrect mixture ratio).
Glue cartridge must be vertical to window glass.
Black ceramic glass impermeable to UV light is located on the peripheral zone of the inside edge of the window to protect the adhesive bead.
Ceramic glass must not be damaged and must be treated as follows.
Treatment of ceramic glass surface (inside of window):
ADHESIVE APPLICATION REFERENCE CHART
| Adhesive (with part numbers) | Treatment |
|---|---|
Repair kit:
|
|