41 11 516 Replacing Left Carrier Support (Partial Replacement, Front Side Panel Removed)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Read contents of BODY, GENERAL .

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Use only approved spot-welding apparatus for repairs, see WORKSHOP EQUIPMENT .

Place vehicle on straightening bench.

Following new body parts are required:

(1) Support carrier, wheel arch, front,

Fig 1: Identifying Support Carrier, Wheel Arch, Front,

G04791197

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Fig 2: Identifying Weld Joint Areas

G04791186

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in areas (1).

Fig 3: Identifying Weld Joint Areas

G04791187

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage to spring strut dome!

Mark severance cut in accordance with measurement a and cut support carrier.

Measurement a=50 mm before 20 mm dia. bore

Installation:

Adjust new part to fit with straightening attachment or universal mount.

Weld in reinforcement plate at severance cut, see 41 00... Welding in reinforcement plate (steel plate) .

Fig 4: Identifying Cut Mark Area

G04791200

Courtesy of BMW OF NORTH AMERICA, INC.