41 34 038 Replacing Outer Tail Panel Section: Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Read contents of BODY, GENERAL and observe relevant procedures.

STRIP DOWN vehicle

Following new body parts are required (refer to BMW Electronic Parts Catalogue):

(1) Rear trim

Fig 1: Identifying Rear Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Carry over the work step shown symmetrically to the other side of the vehicle.

Open weld joints (1).

Open brazed joints (2).

Open spot weld bonding joints (3).

Remove rear trim.

Fig 2: Identifying Weld Joints Area And Brazed Joint Areas

Courtesy of BMW OF NORTH AMERICA, INC.