Installing Rear Trim Panel

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Clean all bonding surfaces on new part and on vehicle with cleaning agent R1.

Apply adhesive to bonding surfaces.

Install rear trim panel and rivet with blind rivets.

NOTE: When mounting rear trim panel, make sure there is sufficient adhesive on bonding surfaces.

Use 11 punch rivets in area (1).

Use 14 punch rivets in area (2).

Fig 1: Identifying Rivet Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Press rear trim panel in areas (1) and remove emerging adhesive.

Install support for bumper trim until the adhesive has hardened.

IMPORTANT: Prevent emerging adhesive from coming into contact with support.

Fig 2: Identifying Rear Trim Panel And Areas Of Emerging Adhesive

Courtesy of BMW OF NORTH AMERICA, INC.

After the adhesive hardens, install 7 EMC SCREWS in areas shown (1).

Fig 3: Identifying Adhesive Areas

Courtesy of BMW OF NORTH AMERICA, INC.