41 61 014 Adjusting Engine Compartment Lid: Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not damage adjoining body parts. Minor corrections (realignment work) are permitted if the existing adjustment options are not sufficient.

NOTE: Observe 41 00... BODY GAP DIMENSIONS . Carry over schematic representation to the relevant vehicle type.

Slacken nuts (1) of hinges on left and right.

Hood lid must be able to be moved.

Tightening torque 41 61 1AZ , see 41 61 ENGINE BONNET/HOOD .

NOTE: If the adjustment range is not sufficient, release retaining screws of engine hood hinge on body and move hinge.

Tightening torque 41 61 2AZ , see 41 61 ENGINE BONNET/HOOD .

Fig 1: Slacken Nuts (1) Of Hinges On Left & Right

Courtesy of BMW OF NORTH AMERICA, INC.

Retaining hooks must snap into place in locks.

Adjust engine hood.

NOTE: Vertical adjustment of engine hood to side panel by means of stop pads.

Fig 2: Locating Stop Pads

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Adjust height of hood/bonnet to front bumper by turning nuts (1) on retaining hooks.

Fig 3: Adjusting Height Of Hood/Bonnet

Courtesy of BMW OF NORTH AMERICA, INC.

If adjustment is necessary, remove front grille . See 51 11 182 REMOVING AND INSTALLING/REPLACING GRILLE IN BUMPER TRIM AT TOP .

Do not slacken nut (2).

Adjust hood/bonnet by turning spacers (1) on both sides.

Fig 4: Adjust Hood/Bonnet By Turning Spacers (1) On Both Sides

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Check function of retaining hook.