LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> X5 35d >> Repair and Diagnosis >> External Pages >> Different car >> Section 2096 (Collision - Body Panel Repair (E71)) >> Body Repair General Information >> 41 00... Opening Rivet Connections >> 2. Opening Punch Rivets >> 2.2 Opening Punch Rivets By Drilling Out

2.2 Opening Punch Rivets By Drilling Out

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Drill out rivets with a 6 mm dia. carbide drill bit.

Punch rivets can be drilled out on both sides. When drilling from the protruding rear side, spot-drill the rivet shank only and remove the rest with a rivet punch.

Use a drift punch to remove punch rivet remnants in the aluminium (risk of corrosion).

Clean vehicle to remove chips (risk of corrosion).

scientia non olet · About LEMON Manuals