Setting Blind Rivets
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
- Position bore holes for blind rivets as specified in repair instruction. If necessary, carry over the positions of the rivets to the new component.
- Drill holes (0.2 mm bigger than the outside diameter of the rivet. Example 4.2 mm dia. for 4 mm rivet and 6.7 mm dia. for 6.5 mm rivet).
- Deburr holes.
- Apply ADHESIVE .
- Insert blind rivet. If necessary, remove adhesive that has emerged.
Position blind rivet tool vertically. Use rivet head extension if accessibility is poor.
- Rivet blind rivet with blind rivet tool. In the meantime clean rivet head if fouled with adhesive. Risk of damage to rivet head by penetrating adhesive.
- Seal blind rivets with Sealant D1 (risk of corrosion).
- Seal cavities after painting vehicle with CAVITY SEALANT (risk of corrosion).