34 51 527 Removing and installing or replacing DSC hydraulic unit: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Read and comply with GENERAL INFORMATION .
- Extract brake fluid
NOTE:
Extract brake fluid out of expansion tank. Use a suction bottle used exclusively for drawing off brake fluid.
Do not reuse drawn out brake fluid.
Do not reuse drawn out brake fluid.
After completing work:
- Bleed braking system . See brake system with DSC .
IMPORTANT:
Do not mix up brake lines.
If necessary, mark before removal.
Brake lines must not be bent.
Close off connection bores with plugs.
If necessary, mark before removal.
Brake lines must not be bent.
Close off connection bores with plugs.
Disconnect plug connection (1).
Unfasten brake lines (2).
Tightening torque 34 32 1AZ . See 34 32 BRAKE LINES .
If necessary, release brake lines from holder on bulkhead.
Unscrew bolt (3).
Tightening torque 34 51 6AZ . See 34 51 SLIP CONTROL SYSTEM (DSC) .
Pull hydraulic control unit with holder out of guide pins (4) and remove.