34 52 525 Replacing one front pulse generator

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) . See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Read and comply with GENERAL INFORMATION .

Disengage cable guides (2).

Open connector housing (1), pull plug connection out of holder and disconnect.

Pull cable with rubber grommet out of holders (3).

Installation:

Ensure proper locking of plug connector and proper seating of rubber grommets.

Fig 1: Identifying Cable Guides And Connector Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage cable guides (1).

Release Torx socket screw (2) and pull pulse generator (3) out of bore.

Fig 2: Identifying Cable Guides And Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.