34 32 861 Replacing all brake pipes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 34 5 100
See BRAKES - SPECIAL TOOLS .
NOTE:
The brake lines are only supplied in the straight version and correct length with connecting nipple.
Read and comply with GENERAL INFORMATION .
After completing work, bleed brake system . See brake system with DSC .
Observe safety instructions on raising the vehicle. See 00....... LIFTING VEHICLE WITH A LIFTING PLATFORM .
Read and comply with GENERAL INFORMATION .
After completing work, bleed brake system . See brake system with DSC .
Observe safety instructions on raising the vehicle. See 00....... LIFTING VEHICLE WITH A LIFTING PLATFORM .
New brake lines are bent into shape with bending tool 34 5 100 .
Removed brake pipes can be used as templates for bending.
IMPORTANT:
- Protective coating of brake line must not be damaged during bending.
- Do not kink or bend back brake lines.
- Watch distances to rigid and movable vehicle parts. Brake lines may not make contact or rub.
- Tighten down brake line couplings with torque wrench.
Installation:
Tightening torque 34 32 1AZ . See 34 32 BRAKE LINES .