33 55 000 Removing and installing/replacing rear stabilizer
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove both STABILIZER LINKS FROM STABILIZER
Release screws (1).
Replacement only: Remove BOTH RUBBER MOUNTS FROM STABILIZER .
Turn stabilizer (2) and remove sideways.
Installation:
Check BOTH RUBBER MOUNTS FOR DAMAGE , replace if necessary.
Align stabilizer centrally.
Tightening torque 33 55 1AZ .