Performing start-up with test run
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of injury!
Vehicle executes heavy rolling motions during start-up! Therefore observe the following specifications without fail:
Vehicle executes heavy rolling motions during start-up! Therefore observe the following specifications without fail:
- Do not allow any persons to remain in the vehicle or directly on the vehicle
- Keep the vehicle doors closed.
- Maintain a safety distance around the vehicle of 1 meter to persons, objects, walls, etc.
- Vehicle must be standing horizontally with all wheels on a firm surface
- Do not under any circumstances carry out start-up on a vehicle hoist, wheel alignment analyzer or similar!
- Avoid heavy loads
- Check load; if necessary, remove load from the vehicle
- Bring engine up to operating temperatureNOTE: Hydraulic fluid temperature must be between 50 °C and 70 °C (vehicle at normal operating temperature).
- Connect vehicle to DIS or MoDiC
- Start start-up in SERVICE FUNCTIONS. Follow instructions in the DIS.
- Check and correct fill level with engine stopped