31 12 003 Removing and installing/replacing top right control arm

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Control arms with + or - marking (see Fig 1 ) are camber correction arms:
- Underdimension variant
+ Overdimension variant

Fig 1: Identifying Control Arms Marking Area

Courtesy of BMW OF NORTH AMERICA, INC.

These camber correction arms are used to correct the camber values by 30 minutes. To be used only if the tolerance values are exceeded or undershot!

An unmarked control arm is a standard part.

Necessary preliminary tasks:

Remove RIGHT PARTITION WALL FOR EQUIPMENT COMPARTMENT
Remove REAR RIGHT WHEEL ARCH COVER

Release screws (1).

Remove auxiliary part (2).

Installation:

When installing, make wiring harness penetration (3) is in correct position.

Fig 2: Identifying Auxiliary Part With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Further procedure is identical to:

Removing and installing/replacing TOP LEFT CONTROL ARM