24 30 101 Replacing oil accumulator (GA8HP45Z) (X6 35i 2011-13)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
- Wear protective gloves.
- Ensure adequate ventilation.
IMPORTANT:
After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only the approved transmission oil:
ATF oil Shell L12108* .............. BMW part number 83 22 2 152 426
* Can be substituted by the lifetime oil "ATF -3".............. BMW part number 83 22 2 305 397
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Installation note:
The transmission oil sump must be renewed every time it is removed.
Installation note:
- Remove transmission OIL SUMP .
- Remove retaining plates.
Recycling:
- Catch and dispose of escaping transmission oil.
- Observe country-specific waste disposal regulations.
Release screws (1) (M6x20).
Release screw (2) (M6x59).
Tightening torque: 8 Nm
Carefully unlock cable connector (3) with screwdriver.
Carefully pull out oil accumulator.
IMPORTANT:
Mounting bolts of oil accumulator must
be replaced after removal.